Direction For Use :

• Reverse Emulsion Breaker 2366 (Polyfloc)c should be injected at a point in the system where agitation (natural or mechanically induced) is sufficient to mix with the fluid to be treated.
   
• Location of the injection point for maximum efficiency will have to be determined empirically, but normally longer mixing times give the best clarification results.
   
• If Reverse Emulsion Breaker 2366 (Polyfloc) is used in secondary treatment of oilfield waters, it should be injected upstream of the
  treating vessel in the pump suction or in the first cell.
   
• Use concentrations can vary from 1 to 100 ppm. Initial use concentration can best be determined by jar tests, while the final use concentration will be determined in the system.
   
• When Polyfloc is used in combination with other water clarification chemicals, injection points it should be separated enough to allow complete mixing of one before the other is introduced. Jar tests will be required to determine which order of addition is most efficient.
   
• Clarification may in some systems may be more effective if the pH of the system is adjusted to less than 7.0.