Use as received to immerse and agitate the parts for 1 - 3 minutes, depending on the condition of the parts before dipping and the desired results. Before dipping, parts should preferably be as chemically clean as before electroplating, but degreasing is adequate, although some shortening of bath life may be expected. Temperature should be kept below 90F for best results. For heavy production, some form of cooling may be required.

Following the dip, rinsing must be thorough to remove the viscous acids remaining on the parts.For subsequent electroplating or water-dip lacquering, no further treatment is required. If the parts are to be dried, a further dip in Quik-Dri 1000 will insure spot free drying and will aid in the tarnish prevention.